Site and capacity survey
bathroom count and available pressure assessed before any unit is chosen

Jahra
Central heater installation in Naeem starts by inspecting existing cold pipes for soundness. We connect the heater to the main cold line and run a hot loop feeding the kitchen and bathrooms. We test each hot tap before leaving site.
Naeem homes are typically simple villas with one bathroom and laundry taps in a rear yard. Old cold pipes are sometimes narrow or have slow leaks, and we pressure-test them before heater connection. If old pipes are weak we suggest replacing the main run with new copper.
Naeem is in Jahra governorate, a relatively older residential area where some pipework may need reassessment.
Each hot tap is run at full flow for one minute to check for air noise or temperature swing.
bathroom count and available pressure assessed before any unit is chosen
tank secured on brackets rated for full operating weight
supply and return lines run at correct fall to prevent stagnation
gas or electrical feed connected with ventilation confirmed before start-up
expansion valve and drain-off valve fitted as standard safety requirements
every joint checked for leaks under pressure before handover
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Narrow pipes cut pressure and slow-leaking pipes reduce available hot water. We test pressure before installation, and if it is weak we identify and replace the weak section.
Air normally bleeds out on its own after a few minutes of heater run. If air persists, we fit an air valve at the loop's highest point or near the heater.
