Burner inspection
Clean and adjust the burner for even, complete ignition every cycle

Capital
Gas heater service in Qairawaan focuses on a complete check of the combustion system, flue and safety. We measure gas pressure, inspect the burner and heat exchanger and piping, test free venting and then restart.
Buildings in Qairawaan near the Seventh Ring Road are mostly multi-storey flats where the gas heater sits in a small kitchen or tight utility room. We carefully disassemble the burner and clean the ventilation ports that clog with dust. The flue rises through an outer wall horizontally or upward, so we check for blockage and ensure condensate drains freely downward.
Qairawaan is a residential district in Kuwait City built with medium-rise apartment blocks near the Seventh Ring Road.
We clean the flue path with a flexible steel rod and blow compressed air to expel dust and moisture completely.
Clean and adjust the burner for even, complete ignition every cycle
Test every joint with detection solution to locate any minor leak
Inspect the flue path and confirm combustion gases exit the space
Measure thermostat accuracy and test the thermal cut-off safety valve
Check the tank body and the sacrificial anode for corrosion progress
Measure incoming water pressure and confirm it suits the unit's rating
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We gently remove the heater from the back wall, then disassemble the burner head and polish gas jet openings with a fine needle. We dry every part before reassembling to avoid traps for debris.
Yes, pooled condensate in flue bends causes rust and blockage. We design the flue to slope downward always and clean the lower section regularly to drain water freely.
