Burner inspection
Clean and adjust the burner for even, complete ignition every cycle

Hawalli
Gas heater servicing in Salwa starts with a full inspection of the burner, combustion chamber, supply lines and flue outlet. We check the pilot lights, thermal insulation and ignition response. We repair any leaks or blockages and run the heater at full load before handover.
Most Salwa villas have gas heaters on the roof or in a side room, many old and unchecked for years. We strip out soot and deposits from the combustion box and heat exchanger, because buildup cuts heat transfer and raises gas use. We inspect the combustion gasket, main and pilot burners and confirm full flue discharge up the chimney.
Salwa is a residential district in Hawalli near Salwa Co-op and Mishref Park, where most homes depend on natural gas heating.
We test the temperature sensor and safety thermostat before handover because either failing can shut the heater down suddenly.
Clean and adjust the burner for even, complete ignition every cycle
Test every joint with detection solution to locate any minor leak
Inspect the flue path and confirm combustion gases exit the space
Measure thermostat accuracy and test the thermal cut-off safety valve
Check the tank body and the sacrificial anode for corrosion progress
Measure incoming water pressure and confirm it suits the unit's rating
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
A weak or flickering pilot is a sign of dust buildup or worn nozzle. We clean it with a soft brush and blow through to ensure a steady blue flame. If it will not light, the burner assembly may need replacement.
Usually no, it is normal condensation from the heat exchanger if the drip is slow and clear. But if the fluid is discolored or heavy, there may be a rust hole in the exchanger and we need replacement.
