Tank body inspection
Checking the outer shell and all joints for seepage or moisture

Ahmadi
Heater leak testing in Shuaiba focuses on long pipes, parallel fittings and voids under floor slabs. We test each pipe section under isolated pressure to pinpoint leak location. Industrial zone heat and intermittent pressure stress heater metal.
Shuaiba industrial zone has commercial buildings and warehouses with high ceilings and thick concrete floors. Large heaters serve multiple floors with pipes running under slabs in tight voids. Extreme heat and moisture from the oil port cause rapid joint corrosion. We check drain lines and flanges with radiography to find hairline cracks invisible to the eye.
Shuaiba is in Ahmadi governorate, an industrial port zone in the oil sector south of Ahmadi City.
We shut each end tap and watch main line pressure drop to find hidden leaks.
Checking the outer shell and all joints for seepage or moisture
Pinpointing concealed leaks by sound without opening the wall
Running a camera into supply or drain lines to trace the moisture source
Inspecting inlet, outlet and surrounding fittings for weeping joints
Checking the area around fuel or power entries for secondary moisture sources
Delivering a clear finding on where the leak is and what repair is needed
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the leak is at a weld, yes; we heat the weld spot from above and re-braze carefully. If the pipe body is cracked, we must cut the concrete and pull the pipe out.
Once under steady pressure for ten minutes, and again after closing the main valve to check drop-off. We never hand over until zero leaks remain.
