Element condition check
Resistance measured to confirm whether element is scaled, shorted or open
Hawalli
Heating element and thermostat in Jabriya
In Jabriya, element and thermostat replacement happens on large heaters hung on the walls of spacious kitchens. We inspect all wiring and pipes and note the old equipment's condition before starting removal. We dismantle the broken element and extract the thermostat and fit a new higher-output element and modern thermostat. We test temperature at the tap and check for leaks before leaving.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Large Jabriya houses have wall-hung heaters because wall space is ample, and these heaters supply multiple hot-water points throughout the house. The element in this heater type may be stronger than a flat-type because it must heat a larger water volume. We inspect copper pipes and fittings for corrosion and white deposits showing mineral scale, and dismantle the mechanical thermostat and test its response before deciding on replacement.
Jabriya lies in Hawalli governorate, a residential district of large family homes near Mubarak Hospital and the American University of Kuwait.
We measure scale thickness on the element with a metal ruler before removal because heavy deposits significantly reduce heat transfer.
What this service covers
Thermostat testing
Cutout points tested and temperature calibration verified before fitting new part
Tank interior inspection
Scale deposits inside the tank assessed as they reduce heating efficiency
Sacrificial anode check
Anode protects the tank from corrosion and is inspected at every service visit
Electrical connections
Wiring and terminals inspected for safety before the new element is energised
Post-replacement test
Heater run and water temperature confirmed at the tap before the visit ends
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Heating element and thermostat
Other services in Jabriya
Gas heater service
See the detailsGeneral heater repair and service
See the detailsHeater leak detection
See the detailsSolar heater repair
See the detailsCommon questions
Questions about Heating element and thermostat in Jabriya
Need someone now? The emergency line is open any hour.
+965 9668 4964
If the element is sound, can we change only the thermostat?
Yes, if we test the element with a multimeter and it shows correct resistance, we replace only the thermostat. But in large Jabriya heaters, element and thermostat often fail together from moisture and high heat.
Does replacing the element affect water pressure elsewhere in the house?
No, replacing the element and thermostat does not alter water pressure. But we test pressure before and after replacement to confirm the problem is not in the main water line or the heater inlet valve.
