Collector panel check
Absorber tubes, flow channels and surface condition inspected for faults

Jahra
Solar heater repair in Amghara begins when hot water stops flowing despite clear sunny days. We inspect panels, pipes, roof tank, electric pump and valves to pinpoint the fault. Then we fix or replace the broken part and run the whole system under full sun.
Most Amghara homes sit on spacious plots with sloped roofs where the solar panel array faces south and the roof tank draws from a well or mains supply. When copper pipes crack under heat or automatic diverter valves fail, hot water stops in summer. We climb to the roof, inspect every joint and pressure-test the system after each repair.
Amghara lies in Jahra governorate, a residential outskirt where high roofs and direct sun make solar heaters a practical choice.
Every system is pressure-tested with cold water first before full sun exposure because sudden pressure breaks thin pipes.
Absorber tubes, flow channels and surface condition inspected for faults
Tank body, thermal insulation layer and sacrificial anode condition assessed
Circulation pump, valves and connecting pipework between panel and tank
Thermostat calibration, expansion vessel pressure and safety valve checked
Acoustic and visual tracing of panel and pipe leaks before any breaking
Pressure and temperature test confirms full output is restored before leaving
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Usually the thermal diverter valve does not open smoothly or a copper pipe has narrowed from internal rust. We disassemble and clean the valve or replace the clogged pipe with fresh copper.
Yes, if the tank bottom rusts or a weld seam cracks. We trace the leak by filling the tank and watching the floor and walls, then replace it with new galvanized steel if confirmed.
