Site and capacity check
Capacity matched to actual household size and usage pattern
Hawalli
Water heater installation in Salam
Water heater installation in Salam starts with checking the cold supply line and existing pipes in the kitchen and bathroom. We select the mounting spot, run copper pipe from the feed point, connect the drain to the nearest trap, fill the system and test temperature before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Most Salam houses have established plumbing basics but old pipework needs careful inspection when connecting a new heater. We trace the cold supply line from the meter and check joint integrity before fitting the hot pipes. If the old pipes are narrow we may recommend a pressure reducer to protect the heater from sudden surges.
Salam sits in Hawalli governorate, an older residential area where installation methods vary by decade.
The heater is run at full flow for ten minutes because old pipework may hold sediment.
What the installation covers
Unit mounting
Secure fixing to wall or platform rated for the tank weight
Water pipe connections
Hot and cold lines connected with heat-rated fittings and isolation valves
Fuel or power connection
Electrical or gas supply connected; ventilation verified for gas units
Safety and expansion valve
Pressure relief valve and expansion vessel fitted before pressurising
Pressure test and handover
System filled and checked for leaks before final handover
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water heater installation
Other services in Salam
Electric heater repair
See the detailsGas heater service
See the detailsGeneral heater repair and service
See the detailsHeater leak detection
See the detailsCommon questions
Questions about Water heater installation in Salam
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can I keep the heater near the existing bathroom or must it move to a new spot?
We usually choose a spot close to both the bathroom and kitchen to shorten the pipe runs. We measure from the meter and drain, then tell you if the current location works or not.
What happens if we find a leak in the old pipes during testing?
We locate the leak precisely and suggest fixing it before connecting the heater. We may replace the damaged pipe section or run a new line bypassing it if access is tight.
