Electronic detection
sensors detect escaping gas through walls without any breaking

Capital
Gas leak checking in Bnaid Al-Qar starts from the coastal main and traces lines to every house, flat and annex. We use a precise electronic detector and confirm each suspect point with soapy water. We isolate the leak, remove the leaking section, fit new approved pipe and fittings, then run a full pressure test before handover.
The coastal zone in Bnaid Al-Qar near the old airport road holds mixed houses, flats and some commercial buildings. Main lines from the street run under sand and sea salt, and leaks always occur at old threaded joints that corrode rapidly. Salty moisture penetrates joints and rusts the threads inside. We remove corroded joints, clean them with a brass brush, re-wrap with fixed PTFE tape and specialist sealant for saline environments.
Bnaid Al-Qar sits on the coast near the old airport road, where main gas pipes are exposed to high humidity and constant salt spray.
Every gas leak in Bnaid Al-Qar results from internal thread corrosion at joints caused by sea salt and moisture.
sensors detect escaping gas through walls without any breaking
network segments isolated and pressure drop measured to find the faulty section
every joint and valve checked with leak-detection fluid where leakage is suspected
gas isolated to the faulty section immediately to keep the building safe
only the damaged section repaired or replaced, rest of network left intact
full pressure test after repair confirms the entire network is tight
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Sea salt and high humidity accelerate corrosion ten times faster than inland zones. Even copper joints suffer rapid surface oxidation and iron threads rust from within.
Yes, standard sealant does not protect iron threads from salt. We use specialist sealant for saline environments with rust inhibitors, and recommend annual joint inspection.
