Electronic detection
sensors detect escaping gas through walls without any breaking

Capital
Gas leak detection in Daiya begins with checking supply lines from the meter to cooking appliances and heaters. We use an electronic detector and apply soapy water to every joint to pinpoint the leak location. Once found, we repair the joint or replace the damaged part, then test the full system before handover.
Most Daiya houses are two decades or older, and central gas lines run from the street through foundations and interior walls to the kitchen and facilities. Old copper and iron joints corrode from moisture, especially near Daiya Co-op. We disconnect leaking pipes and re-run them in copper or galvanised steel tubing to code, with a pressurised air test for leaks before commissioning.
Daiya lies in Kuwait City near the British School, a residential district of older villas and ground-floor flats with long central gas networks.
Every leak we find in Daiya is tested twice: once with soapy water before repair and once with pressurised air after.
sensors detect escaping gas through walls without any breaking
network segments isolated and pressure drop measured to find the faulty section
every joint and valve checked with leak-detection fluid where leakage is suspected
gas isolated to the faulty section immediately to keep the building safe
only the damaged section repaired or replaced, rest of network left intact
full pressure test after repair confirms the entire network is tight
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Copper and iron joints corrode from moisture and oxygen over years, especially if poorly insulated underground. Vibrations from traffic and nearby construction gradually loosen threaded connections over time.
If the leak is at a threaded joint, we remove it and re-wrap it with fresh PTFE tape and sealant compound. But if corrosion has eaten into the pipe body itself, that section must be replaced with new galvanised tubing.
