Electronic detection
sensors detect escaping gas through walls without any breaking
Ahmadi
Gas leak detection in Shuaiba Industrial
Gas leak detection in Shuaiba Industrial starts with a rapid response when a strong sulphur smell appears near the main distribution lines. We bring electronic gas detectors and check every joint and exposed pipe section. We pinpoint the leak source precisely and isolate the affected section before any repair.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba Industrial facilities contain heavy central gas lines running to factories, transformers and large steam boilers. Every metal joint, flange and valve on these lines can corrode from humidity and weather exposure over years. Our leak survey traces pressure from the main inlet through every branch to consumption points, testing each joint with both thermal and chemical detectors together.
Shuaiba Industrial lies in Ahmadi governorate near the KIPIC petrochemical complex, where gas safety standards are stricter than residential zones.
We record the main line pressure at the start of inspection because any drop signals a leak in the previous section.
What this service covers
Pressure test
network segments isolated and pressure drop measured to find the faulty section
Joint inspection
every joint and valve checked with leak-detection fluid where leakage is suspected
Source isolation
gas isolated to the faulty section immediately to keep the building safe
Line repair
only the damaged section repaired or replaced, rest of network left intact
Final pressure check
full pressure test after repair confirms the entire network is tight
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Gas leak detection
Other services in Shuaiba Industrial
Kitchen gas lines
See the detailsRestaurant gas lines
See the detailsCentral gas first-fix
See the detailsPlumbing installations
See the detailsCommon questions
Questions about Gas leak detection in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we tell if the leak is in the main line or a separate branch?
We close each branch in sequence and watch the main pressure gauge. If pressure continues dropping after closing every branch, the leak is in the main line itself. This pinpoints exactly where to dig and repair.
Does a small leak halt factory operations during our detection work?
A small leak usually does not halt operations if adequate pressure stays in the main line. But if the leak worsens we recommend shutting only the affected branch until repair is complete.
