Pressure diagnosis
Pressure measured at multiple points to pinpoint exactly where the fault lies
Ahmadi
Low water pressure in Shuaiba Industrial
Low-pressure diagnosis in Shuaiba Industrial starts by placing a gauge on the main distribution line. The industrial area receives water from distant public reservoirs, and any leak in the network or partial blockage in filters cuts pressure at every tap. We check the meter, pipes and filters, identify the cause and fix it.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shuaiba Industrial buildings include offices, workshops and warehouses fed by shared distribution from a central tank. Low pressure here usually comes from sediment buildup in filters because municipal water carries particles, or from a slow leak in underground lines between the tank and buildings. We open test points on the main line and monitor pressure during peak hours to tell whether the fault is in the building or the public network.
Shuaiba Industrial sits in Ahmadi governorate and houses the Kuwait Petrochemical Industries complex, where workshops depend on steady water pressure for cooling and cleaning systems.
Sand filters in Shuaiba need inspection every three months because municipal water carries more sediment than private wells.
What this service covers
Pump and pressure switch
Transfer pump, pressure switch and expansion vessel checked and set correctly
Scale removal
Mineral scale cleared from pipes, pressure reducers and aerators blocking flow
Pressure regulator
Pressure-reducing valve inspected, adjusted or replaced if it restricts supply
Tank and feed check
Tank level, float valve and inlet pipe verified to rule out supply shortfall
Final pressure test
Pressure confirmed at all outlets after repair before the visit closes
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Low water pressure
Other services in Shuaiba Industrial
First-fix plumbing for new houses
See the detailsMixer and faucet repair
See the detailsPlumbing installations
See the detailsPlumbing maintenance contracts
See the detailsCommon questions
Questions about Low water pressure in Shuaiba Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is my workshop pressure drop a public network fault or a problem in my internal pipes?
We place a gauge on your main inlet line and read it. If the pressure at the entry is below 2 bar the fault is in the public network and the municipality must be notified. If entry pressure is good but taps are weak, you have an internal leak or blockage.
Do mineral deposits in filters cause the pressure loss?
Yes, mineral buildup gradually clogs the sand pores, increasing resistance and reducing flow. We clean filters by backwashing the sand with reverse flow, then retest the pressure.
