Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Ahmadi
Mixer repair at Ahmadi Stables begins by checking the faucet types fitted in horse wash areas and administrative blocks. We diagnose whether the fault lies in the swivel head, handle, body or the runs underneath. We replace washers and springs or clear mineral deposits before retesting under full pressure.
The facilities at Ahmadi Stables have heavy-duty swivel-spout mixers for quick washing, and these faucets face dense water and salt drift from nearby winds. Mineral buildup in the head and handle cuts flow and causes body leaks. We disassemble the head carefully, clean every port and internal ball, then inspect the handle for strain before reassembly.
Ahmadi Stables sits in Ahmadi governorate, a zone where mixer repair serves horse barns and sports facilities alike.
After repair, the mixer runs at full flow for one minute to confirm steady stream with no interruption.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Usually the washer between body and head fails, or the set screw under the sink loosens. We disassemble from below, replace the washer and tighten all fasteners evenly.
Usually yes, if the leak comes from washers or mineral deposits. We disassemble the head, clean deposits from ports and internal cartridge, then reinstall with fresh washers.
