Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Farwaniya
Mixer and faucet repair in Firdous
Mixer repair in Firdous includes pressure and flow checks at the inlet, careful handle removal and cartridge and spray inspection. We quickly identify the fault, replace the damaged part, clean mineral deposits, test temperature and drainage, then set the handle for complete closure before leaving.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Firdous houses are relatively modern with contemporary chrome mixers and a district central screen supplying clean water. But hot water from nearby heaters leaves deposits on cartridges, and daily handle movement wears the valve until it drips. We open the mixer carefully without harsh tools, clean cartridge and valve from limescale with a soft brush. Modern mixers have a built-in flow limiter in the head, so we confirm it is not blocked before reassembly.
Firdous is in Farwaniya governorate on the Sixth Ring Road, a modern residential district with uniform building heights.
Every cartridge extracted from a Firdous mixer is soaked in plain water for two minutes before reinstallation to ensure no limescale or calcium remains.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Firdous
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Firdous
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do calcium deposits on the cartridge need long soaking?
No, a two-minute soak with a very soft brush is enough. Longer soaking may damage plastic cartridge parts. We use white vinegar only if deposits are very thick, then rinse immediately with plain water.
Why does hot water stop at the mixer even though the heater works?
The hot line may be blocked by limescale either near the heater or near the mixer. We check pressure between heater and mixer first, and if it is low we run hot water backward through the line to flush it clean.
