Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Hawalli
Mixer and faucet repair in Hateen
Many older bathrooms in Hateen still have two-handle taps with rubber washers, and our mixer and faucet repair in Hateen treats them differently from modern mixers. A dripping spout usually means a hardened washer or a worn seat, both repairable without replacing the tap.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Compression taps close by pressing a rubber washer onto a brass seat. Over the years the washer hardens and the seat pits, so the tap needs more force to close and still drips. We replace the washer and O-rings, and where the seat is damaged we re-cut it with a seat-dressing tool rather than change the whole tap. In homes near Hawalli that have kept their original fittings, this preserves the existing look and avoids retiling around a replacement.
Hateen, a residential area of Hawalli governorate, still has many bathrooms with their original two-handle taps.
A pitted brass tap seat can be re-cut with a seat-dressing tool instead of replacing the tap body.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Hateen
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Hateen
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do I have to turn the tap so hard to stop the drip?
The washer has hardened and no longer seals against the seat. Forcing it only damages the seat further, so the washer should be changed.
Can you keep my old taps rather than replace them?
Yes, in most cases. Washers, O-rings and seats are all serviceable, so the taps can stay as long as the bodies are not cracked.
