Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed
Farwaniya
Mixer and faucet repair in Khitan Al-Jadida
Mixer faucet repair in Khitan Al-Jadida starts with pinpointing the fault before buying any parts. We disassemble the head, inspect the cartridge, ball or seal rings to identify what leaks or binds. We replace only the worn components and test pressure and temperature before finishing.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Khitan Al-Jadida homes have open-plan kitchens leading into living areas, and the mixer there works hard because hot and cold water switching happens all day. When the faucet begins dripping or whistling, worn ball or cartridge seals are usually the cause from repeated switching. We fully disassemble the faucet and check the small internal ports that feed cold and hot water to the mixing chamber.
Khitan Al-Jadida lies in Farwaniya governorate, a modern residential zone where open kitchens and heavy-use mixers are widespread.
Every repaired mixer is tested under full system pressure and cycled hot-to-cold ten times in succession to confirm no leaks.
What this service covers
Mineral scale buildup
Scale cleared from aerator, filter and internal mixer channels
Reduced flow
Fault located in mixer, supply valve or feed pipe
Incorrect temperature mix
Hot and cold channels checked and balance corrected
Faucet replacement
Old unit removed, new one fitted and pressure tested after
Isolation valves
Valve behind each fixture checked for full shut-off
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Mixer and faucet repair
Other services in Khitan Al-Jadida
Tank cleaning and waterproofing
See the detailsToilet and cistern repair
See the detailsValve repair
See the detailsWater leak detection
See the detailsCommon questions
Questions about Mixer and faucet repair in Khitan Al-Jadida
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does a leaking mixer always need full replacement or can it be repaired?
If the leak is only from under the head, we usually replace the seal rings or ball and the mixer works correctly again. Full replacement is needed only if the body or neck itself is cracked.
Can a dripping mixer be stopped quickly without taking the whole head apart?
No, a dripping mixer requires full head disassembly because the cause is always internal wear in the ports or seal rings. A temporary surface fix will not solve it.
