Dripping mixers
Source diagnosed; cartridge or seals replaced only as needed

Jahra
Mixer repair in Naeem focuses on checking actual water pressure and the condition of tiny holes in the mixer head. We open the head, clean it and test whether leaking comes from the cartridge or from external joints.
Naeem homes are medium-sized with covered kitchens and swivel-head mixers, these heads collect mineral buildup fast from hard water. When spray weakens or one outlet blocks, blocked tiny holes are usually the cause. We remove the mixer head, soak it in mild cleaning solution and gently probe each hole with a thin needle to avoid damaging the silicone ports.
Naeem sits in Jahra governorate, a relatively small residential neighbourhood served by centralised water supply.
We run the mixer head under alternating hot and cold spray to flush holes clean before reassembly.
Source diagnosed; cartridge or seals replaced only as needed
Scale cleared from aerator, filter and internal mixer channels
Fault located in mixer, supply valve or feed pipe
Hot and cold channels checked and balance corrected
Old unit removed, new one fitted and pressure tested after
Valve behind each fixture checked for full shut-off
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
One of the tiny outlet holes in the head is blocked by deposits. We soak the head in mild solution and clean each hole from inside with a thin probe, then flush hard.
Yes the head unscrews easily if holes will not clean or the seal ring cracks. We remove it from the base and fit a new head and test the flow.
