Supply pipework
Hot and cold PPR lines run inside walls to each fixture
Jahra
Bathroom and kitchen plumbing in Jahra Industrial
Bathroom and kitchen plumbing in Jahra Industrial serves factories and workshops with high loads of hot water and drainage. We choose large-diameter pipes and fit expansion tanks to handle the pressure spikes from sudden demand surges.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Jahra Industrial zone houses metal, chemical and machinery factories, each consuming large hot-water volumes at multiple points simultaneously. Supply lines from the main tank must be oversized so pressure does not drop when multiple outlets open together, and steam boilers in factories may send scalding water that needs pre-cooling. Near the Jahra Industrial entry we fit pressure regulators and safety valves on every hot-water line.
Jahra Industrial is located in Jahra governorate north of the capital, focused on heavy and light manufacturing and logistics warehouses.
We test all hot-water plumbing at 60 degrees Celsius for one hour before handover to rule out internal corrosion of pipes.
What the service covers
Drain runs
uPVC drain pipes set at correct fall to prevent sediment buildup
Kitchen plumbing
Dishwasher, sink and grease-trap connections run and tested
Isolation valves
Individual valve per circuit so one fixture shuts off independently
Pressure testing
Network pressurised before plastering to expose any weak joint
Fixture connections
Toilets, basins and mixers connected after final finishes are complete
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Bathroom and kitchen plumbing
Other services in Jahra Industrial
PEX plumbing runs
See the detailsCamera leak detection
See the detailsCentral gas first-fix
See the detailsCentral gas lines
See the detailsCommon questions
Questions about Bathroom and kitchen plumbing in Jahra Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
What pipe size suits a factory needing 500 litres of hot water daily?
We calculate simultaneous flow based on sinks, showers and boilers together, then choose a diameter that holds flow velocity between 1 and 2 metres per second. Usually 32 or 40 mm suffices, but it depends on distance from the tank.
Do factories need isolation valves in every room or at every appliance?
We fit an isolation valve at the entrance to each wing or separate building so water can be stopped for maintenance. On sensitive appliances like boilers we add an extra valve so repairs can be made without cutting water to the whole wing.
