Operation and maintenance contract
Scheduled agreement that sets visit frequency and inspection scope.
Farwaniya
Operation and maintenance contracts in Rai Industrial
Routine maintenance in Rai Industrial stops pipe leaks in warehouses and commercial shops. We inspect pressure on long runs and test valve and impeller capacity every three months.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Warehouses and shops in Rai Industrial have very long supply runs from the main entry point, and pressure drops along the route due to friction and elevation. On routine maintenance we measure pressure at entry and at the last consumption point, and verify that thermal valves do not leak cooling fluid. If we find sharp pressure loss we clean the strainer or replace the worn impeller.
Rai Industrial is adjacent to The Avenues Mall in Farwaniya governorate and contains light industrial buildings with extended supply networks.
We inspect impeller and bearings on every pump after six months of heavy-duty operation because long pipe runs increase rotational load.
What the contract covers
Supply network inspection
Pressure readings and pipe condition checks for scale and corrosion.
Drainage network follow-up
Tracing drain flow and clearing grease traps and outlets before blockage.
Leak detection rounds
Acoustic listening and meter reading to catch hidden wall leaks early.
Pumps and tanks
Checking transfer and pressure pumps and ground and roof tanks.
Visit reports
Written document after every visit listing condition findings and recommendations.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Operation and maintenance contracts
Other services in Rai Industrial
Building and complex maintenance
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Operation and maintenance contracts in Rai Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is low water pressure at the back of the shop a sign of pump failure?
Not always, it may be due to pipe length, friction and elevation. We measure pressure at multiple points on the line and compare readings; if it drops gradually the problem is friction, if it drops sharply the fault is pump or strainer.
Why do you specifically test thermal valves in commercial shops?
Thermal valves protect the pump from extreme temperature rise when flow stops, and leaking oil reduces effectiveness. In commercial shops the load is high and operation is continuous so they need intensive monitoring.
