Position and height
Basin set at a practical height and checked level before any connection is made.
Capital
Ablution basin in Dasma
Ablution basin installation in Dasma begins by checking the old copper pipes running under the raised floors of older houses. We extend hot and cold supply from the nearest distribution point and choose a location close to an existing floor trap. We level the basin, connect the waste and test every joint under full pressure before completion.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Dasma's older houses were built on high foundations with space beneath the floors where new pipes run easily beside existing ones. Floor traps in guest bathrooms are usually sited low and fixed, meaning the new waste line falls naturally without needing to lift any existing pipes. We check the condition of old copper pipes before connecting and clean any scale from the inner walls.
Dasma sits in Kuwait governorate near the city centre, where older residential houses have copper pipes known for durability and stability.
We clean copper pipes inside because hard water in Dasma leaves deposits on the walls.
What the installation covers
Waste connection
Trap and rubber seal fitted so waste drains fully with no odour return.
Supply lines
Braided flexible tails connected to isolation valves for future servicing.
Mixer fitting
Single-lever or separate taps set with PTFE tape and thread compound at every joint.
Silicone sealing
Non-fungal sanitary silicone applied along the full basin perimeter to keep moisture out.
Handover test
Flow confirmed and every joint inspected for drips before the technician leaves.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Ablution basin
Other services in Dasma
Bathtub installation
See the detailsJacuzzi installation
See the detailsShower cabin
See the detailsShower installation
See the detailsCommon questions
Questions about Ablution basin in Dasma
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can old copper pipes be extended safely to feed the new basin?
Yes, if houses have deep foundations with space beneath floors where existing pipes run. We test water pressure first to confirm existing pipes can supply a new point without significant drop.
How do we prevent leaks when connecting old copper to new pipes?
We use soldered copper fittings or calibrated compression couplers sized to the pipe diameter. Each joint is tested with both hot and cold water before sealing the floors.
