Site and drain check
Measure the bay and confirm drain fall before moving the unit

Jahra
Jacuzzi installation in Naeem starts by measuring the tub dimensions and ensuring enough workspace around the house during fitting. We run water and waste lines, mount the pump and perform a full pressure test before use.
Naeem houses have relatively spacious bathrooms and many feature strong concrete floors that support heavy tubs. Most houses in this area have a roof tank instead of direct supply points, so we rely on natural tank pressure to run the pump. The waste line runs under the floor with a steady fall toward the main drain in the house courtyard.
Naeem is a residential district in Jahra governorate comprising family villas surrounded by spacious courtyards.
We check roof tank water pressure using a digital gauge to ensure it is sufficient to run the bubble pump efficiently.
Measure the bay and confirm drain fall before moving the unit
Set the unit level so water drains fully without pooling
Hot and cold lines connected with accessible isolation valves
Deep-seal trap sized to the unit outlet, preventing drain odour
Verify pump connection point and electrical outlet with the electrician
Sanitary silicone on all edges, full water test before handover
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We measure the pressure first with a gauge. If it is below 1.5 bar, the bubble pump may not perform fully. In that case, we recommend fitting a secondary electric pump between the tank and jacuzzi.
We use bent brass fittings and standard sealant at every connection point, then test at 3 bar pressure for ten minutes before handover. If we see any moisture, we tighten the fitting or replace the washer.
