Site and drain check
Measure the bay and confirm drain fall before moving the unit
What installation covers
From site check and drain alignment to jet pump connections and final handover test
Unit setting and levelling
Set the unit level so water drains fully without pooling
Supply line connection
Hot and cold lines connected with accessible isolation valves
Waste and trap fitting
Deep-seal trap sized to the unit outlet, preventing drain odour
Jet pump coordination
Verify pump connection point and electrical outlet with the electrician
Sealing and pressure test
Sanitary silicone on all edges, full water test before handover
How the job runs
First contact
Call or WhatsApp us with the unit type and installation location
Site inspection
We measure the bay and check drain, supply lines and electrical point
Unit installation
Set the unit level and connect supply, drain and pump lines
Sealing and test
Apply silicone to all edges and run a full water test for leaks
Handover
Inspect the unit with us before any wall or floor is closed
Materials and methods used
Non-fungal sanitary silicone
Applied along the full rim to stop water migrating under the unit
Deep-seal bottle trap
Holds enough water column to block sewer vapour from rising through jet inlets
Braided flexible connectors
Absorb minor alignment gaps between wall supply and unit inlets without stressing fixed joints
PTFE tape and thread compound
Used on every threaded joint to hold a seal under the jet pump's operating pressure
Before you call us
Unit and bay dimensions
Have the jacuzzi dimensions and the available bay size ready before the visit
Existing drain outlet position
Note the floor drain opening position and its height relative to the finished tile
Dedicated electrical point
Confirm an electrician has prepared a dedicated earthed outlet for the jet pump beforehand
Nearest isolation valve
Know where the nearest water isolation valve is to speed shut-off when work begins
More in sanitary fixture installation
Washbasin installation
See the details
Wall-hung basin
See the details
Ablution basin
See the details
Western toilet
See the details
Wall-hung toilet
See the details
Shower cabin
See the details
Shower installation
See the details
Bathtub installation
See the detailsPart of Sanitary fixture installation · All services · Back to the home page
What decides the price
No fixed rate: the quote depends on factors specific to each unit and site
Unit type and size
Multi-jet large units need more connections than a compact single-pump model
Existing pipe condition
Old galvanised iron pipes may need partial replacement before the unit connects
Breaking and reinstatement
Adjusting the drain outlet position means separate breaking and tile reinstatement costs
Access and floor level
Upper floors or tight bays increase the labour time required
Connection materials supply
Customer supplying connectors, valves and sealant affects the total quote
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Sanitary fixture installation
- Cistern and mixer repair
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Water pipe leak repair
Restaurants
- Restaurant gas lines
- Gas leak detection
- Kitchen plumbing runs
- Water pump install and service
Complexes and buildings
- Building and complex maintenance
- Roof tank and basement pumps
- Water tank installation
- Operation and maintenance contracts
Why us
Why Al Amana for jacuzzi installation
Amana means trust. Someone else’s home is not ours to be careless in.
Photographed before and after
Do not take our word for it. Look at the work yourself.
We find it before we break it
The leak is marked before a single tile comes up.
24-hour emergency
A leak does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
We cover all of Kuwait
Six governorates, 139 areas.
CapitalHawalliFarwaniyaAhmadiMubarak Al-KabeerJahra
Common questions
Questions about jacuzzi installation
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a jacuzzi be installed in an existing bathroom without extensive tile breaking?
It depends on where the existing drain outlet and supply lines sit. If the connections align with the unit, minimal breaking is needed. If the drain position must shift, targeted breaking is unavoidable.
Why does a drain smell appear from a newly installed jacuzzi?
The most common cause is a shallow trap that dries quickly or fails to hold enough water to block sewer vapour. Fitting a deep-seal trap sized to the unit outlet resolves the issue at source.
Can a jacuzzi be installed in an upper-floor apartment without pressure problems?
A jacuzzi runs its jets from an internal pump independent of building line pressure, so low mains pressure is not a direct barrier. The supply line must still be adequately sized to fill the basin in reasonable time.
How does jacuzzi installation differ from bathtub installation in terms of connections?
Both share supply and drain connections, but a jacuzzi adds a jet pump requiring a dedicated earthed electrical point and extra leak checks on every joint exposed to pump pressure.
Does Kuwait's hard water affect jacuzzi jets over time?
Yes, mineral deposits gradually narrow jet nozzles and reduce flow force. Periodic nozzle cleaning maintains pump performance and extends the unit's working life.
