Frame and tray level
Frame and tray set perfectly flat so water drains fully

Capital
Shower cabin installation in Shuwaikh begins with checking floor level and wall spacing. We position the frame precisely, connect hot and cold supply lines, attach the drain to the floor trap and test the entire seal.
Shuwaikh flats often have cramped bathrooms with uneven floors from original levelling. Before mounting the cabin we check the tile fall toward the floor trap and set metal shims under the frame base to correct level. Tiled walls may be damp underneath, so we ensure they are dry before bonding the rubber seals. The drain must slope steadily toward the trap with no reverse sections.
Shuwaikh lies in Kuwait governorate near Shuwaikh Port and Kuwait Science Museum, a residential district with older apartment blocks where this work is common.
We test the cabin under full flow for one minute with no water leaking from beneath the base.
Frame and tray set perfectly flat so water drains fully
Trap connected to waste line at the correct fall
Flexible supply lines connected to isolation valve and shower outlet
Sanitary silicone applied along every profile edge and corner
Door magnets and hinges adjusted so the panel closes firmly
Water run, drain checked, all edges inspected for leaks
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
We use thin metal shims under the cabin base to adjust for tilt and ensure the door closes smoothly. After mounting, we check level with a laser level before connecting the drain.
No, moisture weakens the adhesive and causes leaks within weeks. We dry the wall with a fan or heater before bonding the seal, then wait six hours before running water.
