Frame and tray level
Frame and tray set perfectly flat so water drains fully

Jahra
Installing a shower cabin in South Jahra begins with checking the bathroom floor and confirming the ceramic or tile is level. We position the frame precisely, fit tempered glass panels, hang the door hinge and test the drain before final silicone sealing.
Family homes in South Jahra are modern, most with spacious master bathrooms sloped towards a floor drain. This natural fall is the foundation of our work, so we set the cabin frame so its floor sits level with that slope. We inspect the frame perimeter for small gaps that might leak spray, then inject silicone into every corner and along the bottom edge.
South Jahra lies in Jahra governorate, a modern residential area where updated bathroom fixtures are increasingly common.
We fill and test the cabin drain at full flow for ten minutes without interruption because any leak shows immediately below the frame.
Frame and tray set perfectly flat so water drains fully
Trap connected to waste line at the correct fall
Flexible supply lines connected to isolation valve and shower outlet
Sanitary silicone applied along every profile edge and corner
Door magnets and hinges adjusted so the panel closes firmly
Water run, drain checked, all edges inspected for leaks
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, if the tiles are firmly set and not loose. We tap-test the area and clean away dirt and limescale before setting the frame, because air pockets under the base cause silicone cracks.
Silicone fully sets after twenty-four hours. We leave the bathroom aired and avoid spraying the fresh joints for three days to allow complete hardening.
