Waste outlet check
Height and position confirmed before the shower tray is set.
Jahra
Shower installation in Mutlaa
Mutlaa shower installation is set at a height matching the natural land slope in this elevated area. We check foundation stability and test lines under high pressure because elevation affects flow strength. We flood the enclosure and base, confirming the drain leaves no moisture beneath the floor before finish.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Mutlaa houses sit on a natural slope with varying foundation heights. This means shower supply pressure may be higher than in low areas, requiring a pressure regulator in the mixer. Drainage benefits from natural land slope, but metal pipes rust faster here due to temperature swings, so we choose strong plastic pipes instead.
Mutlaa is a high natural ridge in Jahra where houses spread across slopes of varying height and wind exposure.
We measure pressure at the shower head immediately after installation and record it visually because high pressure causes joint leaks over time.
What the installation covers
Tray and trap fitting
Tray levelled and trap sealed with a rubber gasket.
Supply line connection
Hot and cold lines connected to the mixer with isolation valves.
Mixer and head fitting
Mixer and arm fitted with thread sealant on every joint.
Silicone edge sealing
All tray-to-wall edges sealed with non-fungal sanitary silicone.
Flow and leak test
Water run and full drainage confirmed before handover.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Shower installation
Other services in Mutlaa
Shower cabin
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Shower installation in Mutlaa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does elevation reduce water pressure at the shower head?
Actually the opposite here, elevation increases pressure if the tank sits higher than the head. But long lines from the tank cause pressure loss, so we measure actual pressure and fit a regulator if it exceeds safe limits.
Do strong Mutlaa winds cause water to escape under the shower base?
Winds do not cause leaks but they pull water sideways during use. Shower enclosure design and wall height protect against this, but we ensure the base seals with high-grade moisture barrier.
