Waste outlet check
Height and position confirmed before the shower tray is set.
Capital
Shower installation in Qibla
Shower installation in Qibla usually begins with removing old angled or dripping heads. We level the wall precisely, run hot and cold lines with correct fall and secure the new head so water drains at a straight angle to the trap without pooling.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many apartments and shops in Qibla near the commercial zone were built decades ago, with cramped bathrooms and sloped old floors. We check the existing waste pipe fall before choosing the head height, sometimes raising the head above standard to reach the floor strainer. Where the floor is nearly level, we use flexible sealing to close the gap between the body and wall.
Qibla lies between Gulf Road and Twelfth Street, a mixed zone of shops and older residential flats where shower installation requires fall correction and solid sealing.
We test the head mounting and all joints under full water flow for one minute before handover to ensure no leaks at any connection.
What the installation covers
Tray and trap fitting
Tray levelled and trap sealed with a rubber gasket.
Supply line connection
Hot and cold lines connected to the mixer with isolation valves.
Mixer and head fitting
Mixer and arm fitted with thread sealant on every joint.
Silicone edge sealing
All tray-to-wall edges sealed with non-fungal sanitary silicone.
Flow and leak test
Water run and full drainage confirmed before handover.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Shower installation
Other services in Qibla
Shower cabin
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Shower installation in Qibla
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the shower be installed without cutting the wall if pipes already exist?
If the old pipe has enough fall, yes, but we check its diameter first. Narrow old pipes may reduce flow or leak when the new head is connected, so replacement or reinforcement may be needed.
How do we stop water leaking around the shower body where it meets the wall?
We use a flexible gasket and moisture-resistant sealant that withstands heat and humidity. It is applied to all gaps around the body and head and left to cure fully before water is run.
