Waste outlet check
Height and position confirmed before the shower tray is set.
Capital
Shower installation in Rawda
Shower installation in Rawda begins by positioning the head on the wall at the right angle to ensure water flows toward the floor outlet. We run hot and cold feeds from nearby connections, test pressure and flow, then secure everything and seal all gaps.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rawda houses have spacious family bathrooms with tiled floors that slope toward a central floor trap, which gives us plenty of room to work. We mount the head around 200 centimetres high and ensure the supply pipe slopes down from the tank to the head, then angle the head so water stays within the tray. After securing it, we clean the joint area thoroughly and seal around the head with a durable waterproof sealant.
Rawda is a quiet residential area in Kuwait City with modern apartment clusters and spacious parks, where complete bathrooms with ready floor drains are common.
Every shower is tested under full flow for at least one minute because morning low pressure can hide a small leak.
What the installation covers
Tray and trap fitting
Tray levelled and trap sealed with a rubber gasket.
Supply line connection
Hot and cold lines connected to the mixer with isolation valves.
Mixer and head fitting
Mixer and arm fitted with thread sealant on every joint.
Silicone edge sealing
All tray-to-wall edges sealed with non-fungal sanitary silicone.
Flow and leak test
Water run and full drainage confirmed before handover.
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Shower installation
Other services in Rawda
Shower cabin
See the detailsWall-hung basin
See the detailsWall-hung toilet
See the detailsWashbasin installation
See the detailsCommon questions
Questions about Shower installation in Rawda
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can the shower head be angled instead of straight down?
Yes, adjustable shower heads let you change the angle to suit your height and preference. We install them so the water stays within the floor tray without wetting surrounding walls.
Do old pipes need flushing out before the new shower is fitted?
If the pipes are old or the water comes out discoloured on first opening, we run the line at full flow for several minutes. This clears loose debris and ensures clean pressure to the head.
