Wall position check
Marking the correct height and anchor points before any drilling
Hawalli
Wall-hung basin in Ministries Area
Wall-hung basin installation in the Ministries Area starts by checking office and corridor walls to find a safe spot away from existing electrical lines and pipes. We set the basin height for the user, anchor bolts into concrete, run supply and waste lines and pressure-test everything before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Government buildings around the Ministries Complex have thick concrete walls and central piping running through main columns. When fitting the basin we avoid these runs and find a clear wall section strong enough for a secure bracket. Waste usually drops inside the wall towards the main drain network below, so we trace existing connection points before drilling.
The Ministries Area lies in Hawalli, an administrative zone where government offices and public services need wall-hung basins that can be cleaned quickly.
We load-test every bracket horizontally before the basin goes on because concrete walls require stronger anchorage than standard partitions.
What the installation covers
Bracket installation
Fitting wall brackets rated to carry the basin weight safely
Supply line connection
Connecting hot and cold lines with new isolation valves fitted
Trap and waste fitting
Setting a new trap and connecting to the waste run at the right fall
Mixer and fittings
Fitting the mixer, strainer and all trim with sealed connections
Pre-handover test
Pressure check, waste flow test and full leak inspection before leaving
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Wall-hung basin
Other services in Ministries Area
Western toilet
See the detailsAblution basin
See the detailsBathtub installation
See the detailsJacuzzi installation
See the detailsCommon questions
Questions about Wall-hung basin in Ministries Area
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do you ensure the basin won't shift or loosen over time?
We use chemical expansion bolts in solid concrete and allow full curing time before mounting the bracket. Then we push hard on the basin before handover to verify there is no movement at all.
Can supply and waste pipes be hidden inside the wall?
Supply lines can run inside the wall if space exists, but waste needs a steady fall so in thick walls we sometimes run it on the surface behind the basin. We scan first to avoid hitting existing pipes.
