Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs
Farwaniya
Plumber (sabbak) in Abraq Khitan
Plumbing repair in Abraq Khitan focuses on pump and fitting faults in modern home supply networks. We test pump pressure and flow before and after main valves. We inspect copper joints for cracks and corrosion. Damaged parts are replaced and filters cleaned of sediment. Testing is repeated before departure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
New family homes in Abraq Khitan use electric water pump boosters between the roof tank and taps. The pump operates under high pressure and may leak from stem seals or stop working. Fine filters before the pump clog with sediment and debris, blocking flow. We disconnect the pump from power then open the isolation valve below it. We go to the tank and open the top valve to bleed pressure. The inlet connection is then disconnected, the filter cleaned and the pump replaced if burnt out. Connections are remade and pressure and flow are tested.
Abraq Khitan lies in Farwaniya governorate, a modern residential area of upscale homes with automatic water pump boosters.
Pump outlet pressure is measured with a gauge because readings above three bar indicate blockage in the indoor line.
What a sabbak handles
Mixers and valves
repair or replacement of leaking or stiff mixers and isolation valves
Water pressure
tracing low pressure to scale buildup, a blocked aerator or a pump fault
Fixture installation
fitting toilets, cisterns, basins and floor drains correctly and leak-free
Post-repair check
pressure test on the line after every repair before closing the wall
Fault diagnosis
locating the exact fault before any decision to break or repair
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Plumber (sabbak)
Other services in Abraq Khitan
Master plumber
See the details24-hour emergency plumber
See the detailsWater pump install and service
See the detailsWater tank cleaning
See the detailsCommon questions
Questions about Plumber (sabbak) in Abraq Khitan
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does the pump stop working weeks after installation?
A pump burns out when current surges or when it draws air instead of water. Air enters if the inlet line sits too high above the tank. We inspect the line, raise it slightly and lower the pump source to correct the difference. Alternatively, the filter may have clogged, causing the pump to suck air and damage the seals.
Can a pump leaking from the base be repaired or must it be replaced?
Leaking from the pump base means the internal stem seals are worn. Repair requires complete disassembly and replacement of seals and stem, which takes time. It is better to replace the entire pump with a new one of the same power and size.
