Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs
Ahmadi
Plumber (sabbak) in Maqwa
Precise plumbing repair in Maqwa requires understanding industrial water networks. We measure pressure and flow, inspect joints and isolation points. We find the true cause and fix it quickly without full service stoppage.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Maqwa is near oil fields with administrative buildings and workshops using heavy water demand. Pipes here are thicker and pressure higher than residential areas. We inspect welded joints, industrial valves and pressure sections. If a leak is from old welding, we replace the faulty section with strong iron or copper pipe.
Maqwa sits in Ahmadi governorate near KOC oil fields, an industrial and administrative district.
We test new pipes at higher than normal working pressure for a duration that confirms each joint is sound.
What a sabbak handles
Mixers and valves
repair or replacement of leaking or stiff mixers and isolation valves
Water pressure
tracing low pressure to scale buildup, a blocked aerator or a pump fault
Fixture installation
fitting toilets, cisterns, basins and floor drains correctly and leak-free
Post-repair check
pressure test on the line after every repair before closing the wall
Fault diagnosis
locating the exact fault before any decision to break or repair
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Plumber (sabbak)
Other services in Maqwa
Master plumber
See the details24-hour emergency plumber
See the detailsWater pump install and service
See the detailsWater tank cleaning
See the detailsCommon questions
Questions about Plumber (sabbak) in Maqwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can welding repair faulty pipes or must they be replaced?
Welding on industrial pipes can weaken metals around the joint. We prefer replacing the faulty section with strong new pipe. Welding is used only in rare cases when no other option exists.
Water is very weak despite a new pump, what causes this?
There may be blockages in valves or the main distribution line. We measure pressure at the pump and at use points to locate where it drops. Deposits in old industrial valves usually cause this.
