Pipe repair
PPR, uPVC and corroded galvanised iron joints and runs

The Salmi area near the Iraq border sees sharp temperature swings between night and day plus high humidity in certain seasons. Villas and commercial buildings there have pipes that rust from inside if made from ordinary iron. When we repair a joint or valve in Salmi we choose stainless steel pipes or copper coated with corrosion protection.
Salmi in Jahra governorate is a border zone near the Kuwait-Iraq border where climate is humid and changeable across seasons.
Every replacement pipe is tested for corrosion resistance in a humid simulation environment for one full hour before final installation.
PPR, uPVC and corroded galvanised iron joints and runs
repair or replacement of leaking or stiff mixers and isolation valves
tracing low pressure to scale buildup, a blocked aerator or a pump fault
fitting toilets, cisterns, basins and floor drains correctly and leak-free
pressure test on the line after every repair before closing the wall
locating the exact fault before any decision to break or repair
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
High-quality plastic pipes withstand humidity, but sharp nighttime cold shrinks them while daytime heat expands them. This stresses the joints. We prefer copper or stainless steel for main lines.
We choose valves made from bronze or stainless steel instead of cheap iron. After installation we apply a thin wax coat to exposed metal parts to keep humidity away.
