Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Ahmadi
Epoxy tank lining in Mina Abdullah
Epoxy tank lining at Mina Abdullah protects against harsh salt corrosion facing coastal tanks near the oil terminal and seaport. We sand and clean all surfaces, apply protective epoxy layers and verify them with thorough visual inspection.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Mina Abdullah tanks sit directly beside seawater and store petroleum products and treated seawater. Salt humidity penetrates hairline cracks and rust spreads fast beneath the surface. We use heavy pneumatic abrasion to remove all old paint, salt and oxide from the walls, then dry the interior with heated treated air before applying epoxy.
Mina Abdullah sits in Ahmadi governorate, a coastal zone where saltwater and humidity affect every tank without pause.
We test every seam, opening and hole for residual moisture before refill approval because moisture causes coating failure.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Mina Abdullah
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Mina Abdullah
Need someone now? The emergency line is open any hour.
+965 9668 4964
How long does epoxy hold before peeling starts at Mina Abdullah?
Properly applied coating lasts eight to ten years before peeling starts, but coastal salt speeds degradation if containment is poor. Annual moisture testing catches problems early.
Can we coat a tank while the terminal operates around it?
Flow to the tank must be stopped and it isolated from delivery lines. Hot work and tool sparks pose a hazard, so we operate under strict coastal safety protocols.
