Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Capital
Epoxy tank lining in Rawda
Epoxy coating in Rawda begins by draining the tank and checking for air pockets under old paint that trap moisture. We grit-blast aggressively until we reach bare metal, then apply epoxy in three phases.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rawda is a green residential zone with many family houses and gardens, and the soil is damp through winter. Air humidity affects tanks and accelerates corrosion inside and out. Many tanks here are built from carbon steel that rusts quickly in wet conditions. Three-coat epoxy forms a thick shield against this ongoing moisture.
Rawda sits near Rawda Co-op and Rawda Park, a quiet leafy residential zone with dense plantings.
After blasting we leave the tank open to dry air for four hours before the first coat because moisture condenses fast on cold bare metal.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Rawda
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Rawda
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does epoxy coating protect against outside rust or inside only?
Epoxy protects the inside only because it reacts with water. The outside needs separate weatherproof paint that handles sun and external humidity. Some owners choose to coat the outside too with flexible weather-resistant paint.
How often must the epoxy coating be redone?
Under normal conditions good epoxy lasts 15 to 20 years before refresh. In high-humidity Rawda it may need renewal sooner if you notice discoloration or fine cracking.
