Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Rawda
Tank welding in Rawda fixes cracks and leaks in large plastic tanks found in villas and apartment buildings. We pressurise the tank, locate the leak, clean the surface and apply the weld precisely, then verify the seal.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Rawda is a quiet residential area with large villas and traditional homes with heavy plastic water tanks on roofs. Many sit at an angle on old metal frames, cracking from repetitive stress. We carefully lift the tank from its tilted support, inspect the bottom inside and out, find hidden cracks under pressure water and weld each with low heat to avoid warping.
Rawda sits in Kuwait governorate near Rawda Park, a leafy residential district with dense vegetation and mature trees.
After welding, we fill the tank, leave water in it overnight and check the crack the next morning to confirm complete healing.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Rawda
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Rawda
Need someone now? The emergency line is open any hour.
+965 9668 4964
Is a leak in the tank bottom more serious than one on the side?
Yes, a bottom crack leaks constantly because pressure is greatest there. We weld it under full water pressure to ensure the repair withstands maximum load.
How many times can the same crack be re-welded?
Usually once, as repeated heat weakens the plastic around the crack. If it re-cracks in the same spot, the tank needs replacement.
