Draining and deep clean
Sediment, algae and corrosion residue removed before any prep begins
Hawalli
Epoxy tank lining in Salwa
Epoxy tank lining in Salwa protects inner tank walls from seepage and corrosion. We drain the tank fully, then scrape the surface to remove scale and old coating. We apply epoxy layers to spec and inspect with a camera before handover.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Salwa houses are mostly villas and some older apartment blocks, each built above a ground tank exposed to sun and heat. This exposure causes conventional coatings to crack and concrete walls to seep slowly. Flexible epoxy withstands the tank's thermal expansion and contraction, and does not react with old tank metals.
Salwa is in Hawalli governorate near Mishref Park, a residential district where most tanks need recoating every fifteen years.
We test epoxy adhesion by spraying water after full cure, because poor bonding causes rapid flaking.
What the lining covers
Surface preparation
Walls and floor abraded so the epoxy bonds without lifting or bubbling
Primer coat and finish coat
Two-coat system builds uniform thickness across all internal surfaces
Hairline crack filling
Fine cracks sealed with filler compound before coating, not over them
Post-cure camera check
Internal camera confirms full coverage and detects any early delamination
Safe return to service
Tank refilled only after the epoxy has fully cured, confirmed on site
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Epoxy tank lining
Other services in Salwa
Tank welding
See the detailsUnderground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsCommon questions
Questions about Epoxy tank lining in Salwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
How long after coating can I refill the tank?
Epoxy needs at least forty-six hours to fully cure at normal temperature. We deliver a calibration cert and you fill it gradually to avoid hydraulic stress before complete cure.
Does epoxy remove old musty smells from the tank?
The coating seals the surface and stops old bacteria growth, but existing water may retain odour. We empty the tank before coating, but if smell persists after fresh filling, flush it once.
