Underground tank cleaning
Removing sediment, algae and buildup from walls and floor
Hawalli
Tank cleaning and waterproofing in Jabriya
Tank cleaning and sealing in Jabriya focuses on removing mineral salts because the local water source carries high levels of calcium and magnesium. We open the tank and rinse it with mild acidic water to dissolve accumulated minerals, then scrub with stiff brush and high-pressure spray until the floor and walls are free of all deposits.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Jabriya is an upscale neighbourhood with family homes and modern buildings near Mubarak Hospital and Jabriya Co-op. Water here is very hard because local wells carry high minerals, leaving a thick white layer of salts on the tank floor and lower walls. We measure this layer thickness and test water pH, then use calibrated first-grade acid solution to avoid etching concrete. After minerals dissolve we rinse multiple times and coat with epoxy protection that stops new salts from building up.
Jabriya sits in Hawalli governorate near Mubarak Hospital and the American University of Kuwait, a district where tanks are affected by local hard water.
Jabriya tanks require mineral removal every two years because hard water builds deposits faster than other Kuwait areas.
What this service covers
Roof tank cleaning
Cleaning tanks exposed to heat and heavy mineral deposits
Epoxy tank lining
Safe epoxy coat that seals the surface and prevents contamination
Fibreglass tank repair
Patching cracks and relining degraded fibreglass tank walls
Tank welding
Closing fractures and openings in steel or polyethylene tanks
Water tank restoration
Full clean, repair and waterproof seal in one organised visit
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank cleaning and waterproofing
Other services in Jabriya
Valve repair
See the detailsWater leak detection
See the detailsWater pipe runs
See the detailsWater pump install and service
See the detailsCommon questions
Questions about Tank cleaning and waterproofing in Jabriya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do mineral deposits build up faster in Jabriya than other areas?
Jabriya local wells carry far higher mineral concentration than central desalination plants. The hotter water gets in the tank the faster minerals settle out, especially summer when roof temperatures climb high.
Does acid solution damage the concrete?
Not if we use the correct dilution and soak only the floor and walls briefly. We test the mix on a concrete sample first then apply to the tank, timing it carefully to avoid leaving it too long.
