Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Ahmadi Stables
Water tank welding at Ahmadi Stables tackles cracks in large plastic tanks feeding cooling fans and standpipes. We inspect the full tank under pressure and pinpoint each leak with water and soap. We scrape the surface around the crack and weld the fracture with a plastic rod or replace the fitting if it has snapped.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Tanks at the stables face year-round sun and constant expansion and contraction weakens seams and walls. The fibreglass tanks here have rigid bodies but the top outlet and side connections leak under pressure and heat. We examine the tank inside and out where possible, measure wall thickness with ultrasound if the leak runs deep, and choose repair method based on crack location and available stock.
Ahmadi Stables sits in Ahmadi governorate and houses equestrian facilities and a racing track that needs reliable water tanks throughout the season.
Every repair is tested by filling the tank and running it under full pressure to confirm the leak does not return before handover.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Ahmadi Stables
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Ahmadi Stables
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a long crack in the tank wall be repaired or must the whole tank be replaced?
Long deep cracks often need replacement because welding may not hold under constant pressure. We measure the fracture first through visual inspection and pressure testing to decide if repair is sufficient.
How long does it take to repair a large plastic tank?
Time depends on tank size, leak location and available stock. A simple repair may finish in hours, but replacing a fitting can take half a day if the tank needs draining and cleaning first.
