Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Doha
Tank welding in Doha addresses repeated failure of welded joints around inlet and outlet pipes on rooftop tanks near the coast. Sea salt accelerates metal corrosion and stresses the weld seams. We remove the old joint, clean salt and deposits, and create a new strong weld that endures the coastal environment.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
The Doha residential and commercial zone contains multi-storey buildings, each holding plastic or metal rooftop tanks. Salt and moisture from coastal air penetrate fine cracks and cause gradual corrosion. We often find leaks around openings where overflow pipes or fill lines pass through, because pipe movement loosens old welds.
Doha is a coastal zone in Kuwait governorate located near Doha Port and serves both residential and commercial uses.
All metal joints in coastal tanks are inspected each season for corrosion because salt shortens weld life rapidly.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Doha
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Doha
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does the old weld around the overflow pipe keep failing in a tank near the sea?
Salt and moisture corrode the metal beneath the weld, and pipe movement during draining and filling stresses it. We remove the weld completely, clean corrosion and create a new joint with a flexible gasket that allows pipe movement.
Does the tank need a protective coating after welding?
Yes, if the tank is metal or if plastic is near salt spray. We apply a rust-barrier coating to the welded joint and surrounding area. This extends weld life in the coastal environment.
