Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in Shuwaikh Industrial
Tank welding in Shuwaikh Industrial focuses on large central tanks serving factories and warehouses. We inspect body cracks or weak flanges under full pressure, weld with precision scanning and test the tank before distribution resumes.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Factories and warehouses in Shuwaikh Industrial rely on large metal and plastic tanks set on concrete pads or steel frames. A large tank faces steady water load and vibration from nearby machinery, so fatigue cracks appear around flanges and the base where pressure concentrates. We inspect the entire tank wall from outside and pressure it slowly while watching for leaks before we begin welding.
Shuwaikh Industrial sits north of Kuwait city and holds hundreds of factories and warehouses, each relying on a central water storage system.
Tank pressure is logged hourly for a full day after welding because large tanks may settle slowly after restart.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Shuwaikh Industrial
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Shuwaikh Industrial
Need someone now? The emergency line is open any hour.
+965 9668 4964
How long does welding a large industrial tank take?
It depends on the number of cracks, their location and tank size. A tank with one crack near the base may take four hours, while multiple cracks may take a full day including drying and testing.
Can the tank be used right after welding is done?
No, the weld must dry fully and cool before the tank is refilled. We run a pressure test three hours after the final weld to ensure joint strength.
