Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Fintas
Tank welding in Fintas starts with a quick check for cracks and loose joints on the shell or base. We locate any leak by filling and watching the water, then dry and clean the area and finish the weld with a protective coat against salt and moisture.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Fintas tanks are mostly half-buried under ground behind houses or in yards near Fintas Co-op, which means constant exposure to soil moisture and sea salt nearby. Poor or rushed welding fails fast in this climate, and a small crack widens into a big hole within weeks. We test a new weld under mild salt-water pressure before accepting the result.
Fintas lies in Ahmadi governorate on the Gulf coast, where salty moist soil and metal corrosion are fast.
Every weld is tested by filling the tank and leaving water for two hours before re-inspection.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Fintas
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Fintas
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does the weld restore the tank to its original strength?
Correct welding seals the crack stronger than the plastic around it, but if the tank is over fifteen years old its material may be brittle and need replacement. We measure wall thickness before welding to advise you on the best choice.
How long does tank welding take?
A small crack on the side takes ninety minutes with drying, testing and cleaning. A long crack or a failed seam takes three hours with cooling time between weld passes.
