Crack welding
direct thermal weld along each fracture line in the tank wall

Ahmadi
Tank welding in Mangaf focuses on repairing stressed joints between the tank body and inlet and outlet pipes. We check every joint under steady water pressure to pinpoint the exact leak. Remove the pipe if needed and weld the spot with a tight repair method. Test the welded joint against full pressure before reinstalling the pipe.
Mangaf houses near Mangaf Co-op rely on small roof tanks fastened with old metal straps, and house movement in intense heat stresses every joint. Supply and drain pipes are exposed to vibration and corrosion, and joint problems first show at the tank edge where plastic meets metal. We check the external fastening and bracket rust before welding.
Mangaf is a residential district in Ahmadi governorate near Abu Halifa, home to family houses with traditional roof tanks.
Tank joints in Mangaf often leak after four to five years of installation because repeated pressure weakens them.
direct thermal weld along each fracture line in the tank wall
re-welding inlet and outlet fittings where the flange joint has failed
resin-and-mat layer over the damaged zone before the final weld seal
internal camera after welding reveals any weak point before refilling
replacing the tank lid when the leak source is the cover seal
written record of weld locations and camera inspection result
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
Yes, we heat the joint to a precise temperature to soften the weld, then remove the pipe slowly while slightly raising internal pressure. After repair we re-weld the joint with a fresh gasket piece.
Yes, old plastic cracks from ultraviolet rays even without damaged joints. We inspect all tank walls under strong light and fill it slowly to see any external moisture.
