Crack welding
direct thermal weld along each fracture line in the tank wall
Capital
Tank welding in NW Sulaibikhat
Tank welding in North-West Sulaibikhat serves modern family homes with medium tanks on roofs and courtyards. We search for cracks at expansion joints, weld with matching rods and test the tank with gradual pressure.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Modern homes in North-West Sulaibikhat have medium plastic tanks set on concrete pads in yards or on roofs. These tanks face daily expansion and contraction from extreme temperatures, so cracks often appear at expansion joints rather than the main body. We inspect each joint carefully because a crack may be tiny at first but spreads fast with repeated daily swelling.
North-West Sulaibikhat is a modern residential area near the Fourth Ring Road with family homes with open courtyards and rooftops.
The tank is tested at partial fill both morning and evening to detect pressure loss as temperature swings between dawn and dusk.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in NW Sulaibikhat
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in NW Sulaibikhat
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why do cracks form specifically at expansion joints?
The expansion joint is meant to move, but if it is tied too tight, swelling pressure concentrates there instead of dispersing. The crack starts at the weakest point in the joint.
How often should the tank be checked after repair?
We recommend a visual check every three months for new cracks around joints. If the tank is older, additional cracks may appear due to underlying weakness.
