Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Shadadiya
Tank welding in Shadadiya starts with full inspection of cracks and damaged joints in plastic and fibreglass tanks. We find leak spots and test tank strength before starting. We clean the area, weld cracks and pressure-test the full tank.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Shadadiya in outer Farwaniya suburbs has homes of varying sizes with tanks of different types and ages. Some tanks are very old and the material has hardened and grown brittle. When we arrive we look for wear marks and fine cracks that grow from edges. We measure tank wall thickness with a special tool to decide if it can be repaired safely or has reached replacement stage.
Shadadiya lies in Farwaniya governorate within outer residential areas where older-aged tanks are very common.
We test old tanks with partial fill first, then add water gradually because brittle tanks can burst under sudden full pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Shadadiya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Shadadiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
How do we know if a tank is too old to be worth repairing?
We look for wear signs, hardening, faded color and repeated fine cracks. If the tank needs three welds or more, or if the material is brittle to touch, replacement costs less than repeated repairs. We give you straight advice during the first inspection.
Is welding a brittle tank different from welding a new one?
Yes, brittle tanks need lower heat and slower welding to avoid worsening hardening. We use more flexible filler material and wait longer for tank cooling. Extra steps protect old material from breaking during repair.
