Crack welding
direct thermal weld along each fracture line in the tank wall
Farwaniya
Tank welding in Ardhiya
Tank welding in Ardhiya repairs damage in commercial and residential fibreglass tanks from intense heat and high pressure. We test the tank with cold water under high pressure to find fine cracks, then weld them with strong resin and fibre.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Ardhiya near the industrial zone has residential blocks and small workshops, all relying on medium fibreglass tanks for cold and hot water. Tanks here face direct sun heat and high pressure from pumps delivering water fast. When tanks age, cracks appear around internal braces and supports, and these structural cracks need deep welding, not just surface repair.
Ardhiya in Farwaniya governorate lies near the industrial zone, where residential and commercial buildings use large fibreglass tanks.
We test the tank under dynamic pressure for four hours because structural cracks may weep slowly under constant pressure.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Ardhiya
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Ardhiya
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a commercial tank be repaired while still in use?
Welding cannot happen with water or pressure in the tank. For small workshops we may cut pressure and drain gradually during work, finishing before peak use.
If cracks are around internal braces, can you reach them?
Yes, we drain it fully and open an inspection port or carefully remove the top. We may use a mirror and extended tools to reach tight spaces around the braces.
