Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Taima
Tank welding in Taima stops the seep causing water waste and dampness beneath the house. We pinpoint the leak, drain the tank as needed, abrade the spot harshly and weld it until it is completely tight.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Taima houses in Jahra's desert suburbs are far from modern water networks and depend on large delivery tanks and rainwater collection tanks. Tanks buried underground face tree roots and cracking from severe daily heat expansion. We inspect inner walls through a small hole with a bright torch, locate every crack precisely, clean it of dust and deposits and surround it with weld that resists pressure and roots.
Taima is a desert suburb of Jahra governorate where homes are scattered and most residents rely on buried water tanks.
We use root-resistant weld material because Taima's buried tanks are exposed to tree roots from nearby growth.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Taima
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Taima
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can cracks in a buried tank be found without heavy digging?
Yes, we open the existing filler port and pass a small camera or bright torch inside the tank. If we see dampness on outer walls we support it with light digging only at that spot.
Are roots around the tank going to damage the weld?
We choose strong flexible weld that roots cannot pierce easily. But if roots are too close we advise trimming distant trees or protecting the tank with an extra concrete layer.
