Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Jahra (Old)
Tank welding in Old Jahra treats plastic and fibreglass tanks serving houses and shops. We locate the leak precisely under pressure, clean the crack thoroughly and apply proper heat to seal it safely for the long term.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Old Jahra around Jahra market and the Red Fort contains old houses and residential buildings with roof tanks twenty years or older. Aged tanks weaken inside from sediment and rust buildup on walls, and may crack under rapid filling. We inspect inside and out, remove deposits from the crack with a wire brush and ensure the zone is completely dry before welding. We apply heat slowly to old cracks to avoid thermal shock.
Old Jahra in Jahra governorate holds traditional houses near the central market, relying on aged tanks for water storage.
We clean deep cracks with low air pressure to remove debris without damaging the tank's thin walls.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Jahra (Old)
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Jahra (Old)
Need someone now? The emergency line is open any hour.
+965 9668 4964
Does an old leaking tank need replacement instead of repair?
Not always, if there is one crack and the wall is not too thin we repair it. But if there are multiple cracks or the walls are very weak, replacement is safer and more lasting.
How do I maintain an old tank after repair?
Flush the tank inside every six months with water and brush to remove sediment. Slow the filling rate by partially closing the valve to avoid sudden pressure on weakened walls.
