Crack welding
direct thermal weld along each fracture line in the tank wall
Jahra
Tank welding in Uyoun
Tank welding in Uyoun starts when a small seep appears in a plastic or fibreglass tank or a joint grows weak. We locate the leak under water, partially drain the tank, abrade the surface and weld it with a tool that fuses plastic or glass fibre together without drilling through.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Many Uyoun houses hold old cracked plastic roof tanks worn by years of heat and ultraviolet light. A tank on the roof is hard to maintain because any seep runs down inside ceilings and walls before it shows. We inspect from inside through the filler opening before welding, then test the repair by pumping water through and waiting an hour.
Uyoun lies near Jahra's natural springs, an old farming district where residents depend on large tanks to store drinking water.
We use flexible weld material on plastic because the tank expands with sun heat and shrinks in cold.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Uyoun
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Uyoun
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a roof tank be welded without taking it down?
Yes, if the crack is on the lower half or side. We climb to the roof, partially empty the tank, abrade the spot and complete the weld from above.
How long must I wait after welding before refilling the tank?
We test it with water right after welding and cooling, on site. If it passes an hour without leaking, the tank is ready for full use.
