Crack welding
direct thermal weld along each fracture line in the tank wall
Hawalli
Tank welding in Zahraa
Rooftops in Zahraa are often tight, with tanks pushed close to the parapet or stair housing, so tank welding in Zahraa has to happen where the tank stands. We reach cracks on the hidden side with angled tools and mirrors rather than dragging a full tank across the roof.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Moving a tank on a small roof risks cracking its outlets and damaging the waterproofing underneath, so we avoid it wherever the crack can be reached. The tank is drained to below the damage, the pipework is left connected, and the weld is made from whichever side gives a clean angle. If the crack truly cannot be reached, we disconnect only the outlet side and tilt the empty tank on padded boards rather than sliding it.
Zahraa is a Hawalli governorate residential area where compact rooftops keep water tanks close to parapets and stair housings.
In Zahraa, tanks are drained only to below the crack, and the pipework stays connected during the weld.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Zahraa
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Zahraa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Do you have to empty the whole tank?
No. We drain it to just below the crack, which saves water and keeps the tank steady while we work.
Can a crack on the back of the tank be reached?
In most cases, yes, with angled tools. If not, the empty tank is tilted carefully on padded boards instead of being dragged.
