Inspection and mapping
Internal camera maps every crack and spalled area before work starts
Ahmadi
Water tank restoration in Maqwa
Tank restoration in Maqwa focuses on checking steel structure and welded joints because tanks there face strong winds and high heat. We assess wall cracks, remove corrosion and apply protective lining before the tank returns to service.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Maqwa tanks sit near oil fields and face fine dust and salt in the air, speeding rust on outer and inner surfaces. Exposed tanks under intense sun expand and contract, stressing welds and causing leaks at pipe joints. We begin inspecting primary welds and the base, then test the entire internal pipe section before deciding whether lining or partial replacement is needed.
Maqwa sits in Ahmadi governorate near KOC oil fields, an industrial area where tanks operate under high environmental stress.
Every weld is tested by dye penetrant method to find hairline cracks invisible to the naked eye.
What restoration covers
Surface preparation
All scale, efflorescence and loose material removed before any filler is applied
Crack filling
Hydraulic mortar seals active and dry cracks in concrete walls and floor
Wall levelling
Repair render restores corroded or pitted wall surfaces to a uniform face
Protective coating
Drinking-water rated coating applied over fully cured and prepared surfaces only
Post-work check
Camera confirms coating integrity and joint sealing before the tank refills
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Water tank restoration
Other services in Maqwa
Fibreglass tank repair
See the detailsRoof tank cleaning
See the detailsTank welding
See the detailsUnderground tank cleaning
See the detailsCommon questions
Questions about Water tank restoration in Maqwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Why does a tank rust faster in Maqwa than elsewhere?
Salt and industrial dust in the air accelerate corrosion of iron and steel. Exposed tanks face this constantly, especially at base levels and joints where water collects.
Will a protective lining survive the harsh heat in Maqwa?
We use heat-resistant epoxy resin rated to 80 degrees Celsius, tested on industrial tanks. We apply it in thin coats, allowing full cure between each layer.
