Crack welding
direct thermal weld along each fracture line in the tank wall
Ahmadi
Tank welding in Maqwa
Tank welding in Maqwa treats cracks in industrial and residential tanks near oil fields. We inspect material quickly, test the crack under water pressure, dry and weld to strict standards because rework is costly in this zone.
- 24-hour emergency
- Camera first, every job
- Leak detection without breaking
- All six governorates
What sets this area apart
Maqwa tanks supply water to workers and staff near KOC oil fields and to local residents. Tanks are large, old and subjected to heavy pressure and high-salinity water. Welding on such tanks demands high standards of cleanliness and dryness, because any moisture leaves voids in the weld that become weak points. We test by filling the tank completely under strict supervision and document each step before returning it to service.
Maqwa is a small industrial and residential zone in Ahmadi governorate lying near oil and gas extraction facilities.
The weld is tested at least one bar pressure for one hour before acceptance.
What the service covers
Joint repair
re-welding inlet and outlet fittings where the flange joint has failed
Fibreglass patching
resin-and-mat layer over the damaged zone before the final weld seal
Seal verification
internal camera after welding reveals any weak point before refilling
Hatch replacement
replacing the tank lid when the leak source is the cover seal
Post-work report
written record of weld locations and camera inspection result
How we work
Our four steps, and you see every one
You call and describe it
Tell us what is happening and where, and the right equipment is loaded before we arrive.
The camera goes down
We film the line from inside and know the kind of blockage and its exact place. No guessing.
We clear it
High pressure water, a machine or a drain snake, whichever the line actually needs.
We film it again
The camera runs a second pass and you see the line clear with your own eyes before we leave.
Who we work for
Same method, same equipment. Only the size of the job changes.
Homes and apartments
- Drain and gully unclogging
- Cesspit suction
- Leak detection without breaking
- Tank cleaning and waterproofing
Offices
- Plumbing maintenance contracts
- Mixer and valve repair
- Low water pressure
- Clearing bathroom lines
Restaurants
- Grease traps
- Commercial kitchen lines
- Restaurant gas lines
- Scheduled clearing and cleaning
Complexes and buildings
- Sewer network maintenance
- Sewage and basement sump pumps
- Manhole and inspection chamber cleaning
- Operation and maintenance contracts
Why us
Why Al Amana
Amana means trust. Someone else's home is not ours to be careless in.
Filmed before and after
Do not take our word for it. Look at the line yourself.
Clearing before breaking
Breaking is the last resort, never the first step.
24-hour emergency
A blocked line does not wait for the morning.
All of Kuwait
Six governorates, 139 areas.
Maintenance contracts
For buildings and complexes, servicing before the problem starts.
We work on commercial sites too
Restaurants, offices and complexes, not only homes.
More areas for Tank welding
Other services in Maqwa
Underground tank cleaning
See the detailsWater tank cleaning
See the detailsWater tank restoration
See the detailsEpoxy tank lining
See the detailsCommon questions
Questions about Tank welding in Maqwa
Need someone now? The emergency line is open any hour.
+965 9668 4964
Can a working tank be welded without shutting it down?
No, the tank must be completely drained first. Trapped water prevents proper drying and ruins weld quality, causing early failure after repair.
What if the crack is near the inlet port?
Welding near ports is harder because metal fittings and plastic expand at different rates. We use slow-set adhesive and flexible coating that tolerates movement between materials.
