Fill valve
Adjusted or replaced when filling is slow, noisy or never stops.

Mubarak Al-Kabeer
Stopping a cistern leak in Mesila starts with thorough inspection of the inlet valve and flush outlet valve and all seals. We disassemble the cistern head clean salt deposits and replace worn parts then test the complete cycle with both brackish and fresh water before handover.
Mesila is very close to the Gulf shoreline and Green Island hotel, and the water system mixes fresh and brackish water. Cisterns here face salt deposits stronger than anywhere else in Kuwait. We remove the entire cistern head and clean the seats with weak acid solution then flush with fresh water. New seals must be salt-resistant material, and we test the valve with brackish water simulating actual conditions.
Mesila lies near the Gulf shore and Green Island area in Mubarak Al-Kabeer governorate where salinity is high.
Every cistern is tested by spraying brackish water on valve and seals because salts accelerate wear under heat.
Adjusted or replaced when filling is slow, noisy or never stops.
Repaired when water trickles constantly from cistern to pan.
Set or replaced to restore the correct water level inside.
Checked and reseated when the joint leaks at floor level.
Broken or loose seats replaced on the same visit.
Wax or rubber seal replaced when water pools at the base.
How we work

Tell us what is happening and where, and the right equipment is loaded before we arrive.

We film the line from inside and know the kind of blockage and its exact place. No guessing.

High pressure water, a machine or a drain snake, whichever the line actually needs.

The camera runs a second pass and you see the line clear with your own eyes before we leave.
Same method, same equipment. Only the size of the job changes.




Why us
Amana means trust. Someone else's home is not ours to be careless in.
Do not take our word for it. Look at the line yourself.
Breaking is the last resort, never the first step.
A blocked line does not wait for the morning.
Six governorates, 139 areas.
For buildings and complexes, servicing before the problem starts.
Restaurants, offices and complexes, not only homes.
Common questions
Need someone now? The emergency line is open any hour.
+965 9668 4964
No, but it is the main reason. Salts deposit on seats and seals preventing complete closure. Additionally the cistern itself may be corroded inside or pipes may be rusty. We inspect the entire cistern and scrape any rust before replacement.
At minimum every six months we recommend inspecting the valve and seals. If you see white salt crystals on brass parts call us for quick cleaning and maintenance. Early maintenance prevents leaks before they start.
